Call us and describe it. Over the phone you'll get a typical range, and the exact figure goes into a written quote once we've walked the lot and seen what's under the tree, before any work starts. Some trees just need a prune.
Does the tree really need to come out?
Not always. A single dead or damaged limb is a pruning job. We cut it outside the swollen ring where the limb meets the trunk (the branch collar), never flush to the trunk, so the tree can seal the wound. A tree with a bad crack, a split fork or a lean that keeps getting worse is a different matter, and removal is usually the safer call. A tree that's only thin or slow can often be treated, and the saw stays in the truck until we've walked around the whole tree.
When you are ready, tree pruning is the place to start. Searching for tree service in Dubuque? See our home page.
How we take a tree down next to your house
Before the first cut, we mark off a drop zone that reaches out twice as far as the tree or limb is tall, and nobody stands in it while we cut or lower branches. That means keeping kids, pets and neighbors clear, and it's why we ask about fences, sheds and cars when you call.
We choose a safe route up into the tree, and a climber never moves without a secure tie-in point still attached; one anchor stays on at all times, even while repositioning. Pieces are cut and lowered, not just dropped, when something you care about is underneath.
We also look at your roof covering before deciding how to protect it. Slate, which went onto a lot of the larger, high-style Dubuque houses, needs different handling than fiberglass, metal or architectural asphalt shingles, and a falling piece or a boot in the wrong place can do very different damage to each.

What does the stump grinder run into on Dubuque slopes?
Slopes and shallow rock. Dubuque-series soils sit on hillsides, with loess over clayey material and limestone underneath, so runoff can leave the ground slick and the grinder can hit rock close to the surface.
That affects how we get the stump grinder to the stump and how deep we can go, and it affects the time and price. Tell us if the stump sits on a slope or behind a gate, and we'll plan for it. Leaving the stump, or planting right beside it, is your call, and the written quote reflects whichever you choose.
Is the tree yours to cut?
If any part of the tree stands in the public right-of-way, you need City permission or a permit through the City Forester before it comes down or gets pruned. Ownership gets checked before we schedule, not after, because a tree on the city's side of the line is not yours to remove. The distance from the tree to the street or sidewalk tells us whether it's likely on the city's side.
What will removal cost me?
For a tree under 30 feet, figure $150 to $425. Medium trees, 30 to 60 feet, run $150 to $425. Those ranges are what we can quote you on the phone.
Height, distance from the house or wires, whether equipment can reach the tree or pieces have to be rigged and lowered by hand, and whether you want the stump ground all move the number within that range. Slopes and shallow rock push a stump job up. The written quote lists what's included, so you know your number before we start.
Ready to talk it through?
A rough height, how close the tree stands to the house and whether it's near the street are enough for a ballpark. Nothing gets decided on that call. The exact price is written down once we've seen the tree in person.
Some of the Specifics
On a typical job, the job can include:
- Walk the site before work and identify overhead lines, damaged limbs, tree lean, nearby structures, traffic, and unstable ground.
- Check the tree’s health and structure before deciding whether it can safely support climbing, rigging, or cutting loads.
Related Services
Fast Scheduling
Talking it through by phone takes a few minutes, and there's no pressure to book.
Updated November 2026